Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner & SpeedBrake, For use with Banks iQ '03-07 Compatible with PowerPDA User Manual
Page 27
96825 v.6.0
27
Figure 28 Banks iQ System
OBD II connector. Next, connect the
6-pin connector on the Banks OBD II
interface cable to the 6-pin connector
on the Six-Gun/EconoMind Tuner
harness.
9.
Locate the RJ12 cable (similar to
telephone connector) on your Banks
OBDII interface cable. See Figure 28.
10.
RJ12 Connector without SpeedBrake
Banks iQ: Locate Banks iQ Bridge
Module and connect the RJ12 connector
into the Bridge Module. See Figure 29.
11.
Route the Banks iQ USB interface
cable from the Banks iQ Bridge Module
under the dash and out through the
side access panel opening. The cable
can be slid under the door frame’s seal
and run up to the top of the dash. Pull
enough cable to reach the Banks iQ
and connect it to the USB receptacle
on the left side of Banks iQ. See
Figure 25. Snap the side access panel
back in place making sure not to pinch
the wire.
WARNING: THE CHARGING CABLE
CONNECTED TO THE BANKS iQ IS
DESIGNED TO SUPPLY A CONSTANT
LOW-VOLTAGE POWER SOURCE
(+5VDC) TO THE BANKS iQ AND IS
“LIVE” AS LONG AS THE SYSTEM’S
OBD II INTERFACE CABLE OR BANKS
WIRING HARNESS IS COMPLETELY
INSTALLED AND THE USB CABLE
CONNECTOR IS PLUGGED INTO
BANKS iQ. ALTHOUGH THIS
CHARGING CABLE IS SHORT AND
ITS CIRCUITRY IS FUSE-PROTECTED,
THE USER IS ExPECTED TO TAKE
APPROPRIATE MEASURES TO
PREVENT SMALL CHILDREN AND/
OR PETS FROM CONTACT WITH ANY
PART OF THIS SYSTEM.