Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Tuner- Six-Gun Diesel Tuner '07-09 (PDA) Compatible w_ Optional PowerPDA User Manual
Page 14
14
96508 v.7.0
Not needed if the optional Banks
PowerPDA is installed.
CAUTION: Do not use force
when working on plastic parts.
Permanent damage to the part
may result.
Note: Before drilling, confirm that
there is adequate room for the switch
and wires behind the dash. Make sure
wires or obstructions are cleared from
the drilling area.
From where the six-Gun switch will
be located, make sure there is enough
wire on the In-Cab Cable to reach the
switch.
1.
The Six-Gun Switch can be installed
on the driver’s side of the instrument
panel (IP) to the left side of the
steering column. There are two dash
types: Dash 1 (Figures 10, 11) and
Dash 2 (Figures 12, 13).
Note: these are just suggested
locations. It is possible to locate
the six-Gun switch where it is more
comfortable. Please confirm space
behind dash before drilling.
2.
To install on the driver’s side IP
(Dash 1, Figure 10):
Pull the IP trim out by pulling the top
edge above the vent as shown in
Figure 14. Disconnect any switch
wires.
3.
Cut out the supplied template,
Figure 23, and align the dashed lines
to the edge of the IP where you would
like to mount the Switch. Tape the
template in place. Continue to Step 7.
4.
To install the Switch to the left side
of the steering column (Dash 2 Figure
13):
Remove the fuse access panel shown
in Figure 7. Remove the lower knee
Section 3
INSTALLATION OF THE (OPTIONAL) SIx-GUN SELECTOR SWITCH
Figure 10
Figure 11