Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Tuner- Six-Gun Diesel Tuner '07-09 (PDA) Compatible w_ Optional PowerPDA - Manual (Page 18)

18
96508 v.7.0
10.
After confirming the locating
washer is in the #6 location, install
the Switch through the 3 ⁄
8
” hole. The
alignment pin should rest in the 1 ⁄
8
”
hole. With the Switch fully rotated
counter clockwise the shaft’s flat
side should be facing the steering
column. Secure the Switch with the
internal tooth washer and nut. Snug
the washer; be careful not to over
torque the nut and damage the plastic
threads.
11.
Install the knob onto the shaft
facing the #1 Level on the Six-Gun
label. On the knob, snug the two (2)
set screws with the supplied 0.050”
hex key wrench.
12.
Route the Six-Gun Switch
Cable down to the Six-Gun Diesel
Tuner’s In-Cab Cable underneath the
dashboard, and reinstall any panel(s)
that were removed.
Note: take care to keep any cables
away from the pedals or where they
could become tangled.
13.
Connect the Six-Gun Switch’s
2-terminal receptacle to the 2-terminal
plug on the Six-Gun Diesel Tuner’s
In-cab cable.
12.
Re-connect the negative (ground)
cable(s).
-END, SECTION 3-
Figure 18