Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Tuner- Six-Gun Diesel Tuner '07-09 (PDA) Compatible w_ Optional PowerPDA User Manual
Page 16
16
96508 v.7.0
bolster panel by removing the 2
Phillips screws on the lower edge
of the panel. Using a 10mm socket
and ratchet, unbolt the brake release
lever. Pull the panel out by grasping it
on either side of the steering column
and pull out as shown in Figure 15.
Disconnect any switch wires.
5.
Cut out the supplied template,
Figure 23, and align the template
to the right edge of the IP to the left
of the steering column. Tape the
template in place. A 90° drill will be
needed to drill the hole. continue to
Step 7.
6.
To install Switch as shown in
Figures 11 & 12:
Follow Step 4 to remove the IP for
both Dash styles. Cut out the supplied
template, Figure 24, and align the
template onto the rear of the knee
bolster, squarely seating it into the
panel corner as shown in Figure 16.
7.
Using a
3
⁄
8
” Uni-bit step drill bit or
a
3
⁄
8
” drill bit, center the bit onto the
3
⁄
8
” drill location on the template and
slowly drill through the IP. Using a
1
⁄
8
”
drill bit, center and drill through the
1
⁄
8
” location on the template. Remove
and discard the template and any
plastic shavings.
8.
On the front side of where the
Switch will be mounted, clean the area
with some alcohol and allow it to dry.
Remove the backing from the Six-Gun
Label and align it over the previously
drilled hole.
9.
Remove the nut and internal tooth
washer from the Six-Gun Switch.
Rotate the shaft counter clockwise
until the shaft stops. Verify the locating
washer tab is inserted into the #6
position on the Switch (Figure 17).
Note: If the washer is in any position
other then the #6, your six-Gun Diesel
tuner will not select power levels
properly.
Figure 15