Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Tuner- Six-Gun Diesel Tuner '07-09 (PDA) Compatible w_ Optional PowerPDA User Manual

Page 25

Advertising
background image

96508 v.7.0

25

If the Six-Gun Diesel Tuner has been

moved to a different vehicle, or you

are instructed to do so by Banks

Technical Staff, it is possible to reset

all of the parameters that the Six-Gun

has ‘learned’ - presence of an EGT

thermocouple or Speed-Loader, etc.
CAUTION: The following procedures

can only be carried out with the

engine OFF!

1.

Turn the vehicle key to ON but DO

NOT start the engine.

2.

Fully depress the throttle pedal

and then release it completely.

Repeat 5 times. The Tuner’s GREEN

LED will flash when this is completed

successfully.

3.

Turn the key OFF. Wait 60 seconds

and make sure the GREEN LED goes

off and stays off. Turn the key back to

the ON position but DO NOT start the

engine.

4.

Fully depress the throttle pedal and

then release it completely. Repeat 5

times.

-END, SECTION 9-

Section 8

CLEARING LEARNED INFORMATION

If the Six-Gun Diesel Tuner should ever

need to be removed from the vehicle,

perform the following:

1.

Disconnect the negative (ground)

cable from the battery (or batteries, if

there are two) before beginning work.

2.

Disconnect the Six-Gun’s gray

connector from the factory harness.

3.

Re-connect the vehicle’s gray

connector back into the factory

harness.

4.

Disconnect the Six-Gun’s black

connector from the factory harness.

5.

Re-connect the vehicle’s black

connector back into the factory

harness.

6.

Disconnect the EGT thermocouple

connector. The thermocouple may be

left in place or removed if a suitable

plug is used.

7.

Disconnect the ‘In-Cab Cable’ and

gently pull the cable back through the

firewall.

8.

Remove the Six-Gun Diesel Tuner.

Failure to follow the above instructions

when removing the Tuner will result

in a “check Engine” light on the dash

and a Diagnostic Trouble code being

stored in the factory computer, in

addition to the engine not running.

4.

Re-connect the negative (ground)

cable(s).

-END, SECTION 10-

Section 9

REMOVAL OF THE SIx-GUN DIESEL TUNER

Advertising