Grain Systems PNEG-950 - Manual (Page 40)

PNEG-950 40
Setting Up The Temperature Set Points
These set points are monitored by the computer to control certain features of the dryer. These can be adjusted
from the keypad of the Dryer control panel using the button or the button.
Moisture Control Setpoint
Drying mode switch is in the Continuous position:
If the moisture control temperature is below this set point and you have your unload switch set to two speed
position then meter rolls will discharge the grain using the low speed meter roll setting.
If the moisture control temperature is above this set point and you have your unload switch set to two speed
position then meter rolls will discharge the grain using the high speed meter roll setting.
It is normal for the meter rolls to switch back and forth between high and low speed during the drying pro-
cess. This regulates the speed of the grain being discharged from the dryer.
Drying mode switch is in the Batch position:
If the moisture control temperature is below this set point and the Dry Timer has reached zero, the heater will
continue to fire until the moisture control set point has been reached. During this cycle the moisture control
light will flash and a message on the display will read TEMPERATURE HOLD.
To change the setting of the moisture control temperature follow these instructions:
1. Press the temp button.
2. Press the button.
3. Press the button to adjust the settings.
4. Press the button to accept the changes.