Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-681 - Manual (Page 17)

PNEG-681 Series II Bucket Elevator 17
7. Trunking
Standard Trunking
Standard trunking sections may be fabricated from painted or galvanized steel.
IMPORTANT: Galvanized steel trunking MUST have the riveted (huck bolted) seams located to the inside,
facing each other on the up-leg and the down-leg. (See Figure 7B.)
NOTE: Trunking sections come complete with appropriate hardware and two (2) tie angles. Units
containing 42" diameter or larger pulleys have a cross tie angle included for additional support.
Figure 7A Painted Trunking Figure 7B Galvanized Trunking