Grain Systems Tanks PNEG-4105A - Manual (Page 115)

Chapter 7: Roof Assembly
Attaching the A-Frame to the Eave Bracket
Assemble the lower portion of the A-frame rafters to the sidewalls.
1. Lower the A-frame rafter assembly (A) along the side of the eave bracket (C), and align with the
proper holes.
NOTE: Use the alignment hole (E) in the rafter to help align the holes with a punch tool.
2. Install flange bolts (B) and flange nuts (D), securing one side on the A-frame assembly.
3. Repeat this procedure for the other side of the A-frame.
4. Tighten to the recommended torque specifications. See Bolt Torque Specifications, page 25 .
Figure 7-31 Attaching the rafter to the eave bracket
A A-frame rafter assembly D 1/2 in. flange nut (S-10253)
B 1/2 x 1-3/4 in. flange bolt (S-10252) E Hole for alignment tool
C Eave bracket (CTR-0441)
After You Finish
Continue to the next A-frame installation until all of the A-frame rafter assemblies are installed. See
About
Temperature Cable Brackets and A-Frame Assemblies, page 83 .
Assembling the Roof Panel Clips
The roof panel clips are located at the top of the roof rafters nearest to the center collar rafter clips.
Before You Begin
Pneg-4105A 105 Ft Diameter 40-Series Bin 115