Grain Systems Tanks PNEG-4105A - Manual (Page 173)

Chapter 8: Accessories
Figure 8-31 Exploded view of wind ring installed at upper portion of stiffener
A Flange bolt with sealing washer (part
number will vary) G 7/16 in. hex nut (S-9281)
B Wind ring bracket (CTS-1005) H 3/8 x 1 in. flange bolt (S-7485)
C Stiffener (part number will vary) I C-clamp (SS-7248)
D Flange nut (part number will vary) J 3/8 in flange nut (S-9426)
E Wind ring section (CTS-1004-XX or CTS-
1002–XX)
9
K Wind ring coupling collar (CTS-1006)
F 7/16 x 3-1/4 in. flange bolt with sealing
washer (S-10261) L Field drilled hole location
Assembling Weather Cover for Roller Valve
The following instructions are for assembling the weather cover for the roller valve.
1. Install the weather cover kit after the gate has been installed.
2. Use bead caulking at all seams where the weather cover attaches to the gate.
3. Use hex bolts (C) and flange nuts (D) to plug all holes not in use.
4. Use 1/4 in. self-drilling screw (B) to seal gate end plate corners.
Pneg-4105A 105 Ft Diameter 40-Series Bin 173
9. (-XX) denotes the bin diameter.