Flashing installation, Grain systems formed flashing installation – Grain Systems Bin Flooring PNEG-1324 User Manual
Page 20
Advertising
3. Installation
20
PNEG-1324 72', 75', 78', 90' and 105' Cor-Lok and Cut-Lok Flooring
Flashing Installation
Figure 3E
Grain Systems Formed Flashing Installation
If bin sweep auger is to be used, overlap flashing such that rotation (usually clockwise) of the sweep will
climb up on the next flashing section. This will prevent the rotating/slipping outer wheel of the sweep from
catching on the flashing edges.
After the floor is in place, lay the flashing pieces on top of the floor place over the 1-1/4" bin bolts.
below to determine the correct sequence for placing the nuts and washers. Finger tighten
the nuts. While holding flashing flat, fasten the flashing to the floor with sheet metal screws. Now tighten
flashing nuts.
Figure 3F
Advertising