Grain Systems PNEG-1781 - Manual (Page 7)

PNEG-1781 Field Installation of Sidekick™ Moisture Sampler Kit 7
3. Installation
Figure 3A
NOTE: Belt guard removed for instructional purposes only. All guards should be in place when
in operation.
Remove Previous Moisture Sampler
1. Disconnect all power sources to equipment.
2. Disconnect any unload equipment mounted or attached to the current rear discharge box.
3. Remove belt guard, belt and the drive sheave on the unload auger shaft.
4. Detach the rear bearing from the discharge box and slide off shaft.
5. Detach the tilt switch from its cord and pull the cord out of the assembly after loosening the cord
connectors. Unlatch the moisture sensor.
6. Remove the eight (8) nuts and bolts between the rear discharge auger tube and the rear of the dryer.
The old discharge and moisture sampler can then be removed.
7. Just beyond the last wooden hanger bearing, remove the discharge auger section from the stub in
the shaft under the bearing. You are now ready to install the Sidekick™ Moisture Sampler Kit.