Grain Systems PNEG-1781 User Manual
Page 9
3. Installation
PNEG-1781 Field Installation of Sidekick™ Moisture Sampler Kit
9
4. Slide the lock collar (D32-0001) onto the rear auger stub (D01-1994) and then the rear bearing. The
bearing can now be mounted to the discharge box and then the lock collar set.
Figure 3C
5. Attach the drive sheave (018-1047-2) on the rear auger stub with the split taper bearing (D32-0016).
If not already installed, attach the sheave (017-1451-8) to the moisture sampling auger (D04-0641)
with split taper bushing (FH-5536) and square key (S-8426).
6. Run the moisture sample belt (D03-0848) between the two (2) sheaves, taking note of the arrows to
indicate direction.
7. Run electric cord back into conduit and attach the tilt switch.
8. Place the moisture sensor in place on the sampling column and use the over-center latches to
mount it.
9. Re-connect the unload equipment to the bottom of the rear discharge box.
10. Finally, bolt the belt guard in place.
NOTE: Moisture sample belt (D03-0848) is not shown.