Grain Systems PNEG-1758 User Manual

Page 5

Advertising
background image

1. Competitor/Dri-Tek Control Panel

PNEG-1758 Competitor/Dri-Tek Control Panel

5

Dryer Control Panel Featuring the Series 2000 Control System

The control panel provides easy access to gauges and controls. The Competitor Series 2000 Control
System is a computerized control system that gives instant information regarding dryer operation.

Moisture Control (Temperature Based)

The Series 2000 dryer has a built in moisture control. It controls the moisture level of discharged grain by
sensing grain column temperature.

Moisture Control Switch

This switch turns the power ON or OFF to the moisture control. The light beside the switch is illuminated
when the grain column temperature is below the moisture control setpoint.

Control Power Switch

The power to the Series 2000 Control System is turned ON or OFF with this switch.

Outside Light

The dryer outside light is turned ON or OFF here.

Drying Mode Switch

This is used to select staged batch or continuous flow drying.

Load Auger Switch

This is used to select the operation of the fill auger. In both the AUTO and MANUAL positions, the load
auger will operate if the dryer is low on grain and will automatically shut off when the dryer is full. In the
AUTO position only, the dryer will shutdown after a preset period of time set on the out of grain timer.

NOTE: If the load auxiliary motor overload relay is being utilized in the dryer control panel, this switch will

also control the operation of the auxiliary equipment.

Fan Switch

The fan is turned ON or OFF with this switch. The ON position operates the fan continuously during staged
batch and continuous flow modes. The AUTO position is used in batch mode only and allows the fan to
shutdown during the unloading operation if desired. The light comes ON only when air pressure is sensed.

Heater Switch

This switch is used to turn the burner ON or OFF. The ON position will operate the burner continuously,
but only when the fan is running. The AUTO position is used in batch mode only and allows the heater to
be turned OFF to cool the grain and during the unloading operation. The burner light comes ON only when
flame is detected.

Advertising