Grain Systems Bin Accessories PNEG-066 - Manual (Page 16)

16 PNEG-066 2.66" & 4.00" Side Draw Installation
4.00" Side Draw Systems
Discharge Tube Installation
1. Use bottom holes in last chute to locate discharge tube. See Detail "B" for hole dimensions in sidewall
sheet. (Approximately 14" below 5th horizontal seam.)
2. For proper watershed, install plate so upper body sheet overlaps plate as in detail "C".
3. Use discharge tube assembly for template. Drill all holes 3/8" diameter.
4. Use 2 beads of caulking to seal discharge plate to body sheets, use 3/8" bolts and nuts provided to bolt
discharge sheets to body sheets.
11"
7-1/2"
14"
7" 5th RING SIDE SHEET
FROM BASE
1-1/2" MIN RAD. AT
CORNERS
DETAIL "B"
19"
22"
DETAIL "A"
WIND RING
INSTALLATION
Installation of side draw
systems on some 4.00"
Corrugation tanks require
additional wind rings.
NOTE: Unloading tube and
support from rack and pinion
are not provided by G.S.I