Grain Systems Bin Accessories PNEG-1773 User Manual
Page 48
4. Assembly Instructions
48
PNEG-1773 42'-135' “X” Series Ladder, Cage and Platform
NOTE: See table
for correct ladder and safety cage layout.
1. Assemble the wall bracket to the wall angle using 3/8" hardware.
NOTE: The wall angle must be assembled on top of the previous wall angle to provide a flat surface
to mount the wall bracket.
2. Assemble the wall braces to the wall bracket and the horizontal sidewall seam using 5/16" hardware.
IMPORTANT: Use a hole in the horizontal seam and two (2) holes in the wall braces that allows the
wall bracket to be aligned with the above wall bracket. If they are NOT aligned, the
ladder will not be straight.
3. Attach the next ladder section to the upper section using the splice plates and 5/16" hardware.
Assemble the ladder standoff brackets to the ladder and wall bracket using the ladder standoff
wedges and 5/16" hardware.
Figure 4AB