Grain Systems Tanks PNEG-1460 - Manual (Page 26)

26 PNEG-1460 6', 7' and 9' Bulk Feed Tank BFT Series and GHT Series
7. Roof
Sealed Roof Panels Installation
NOTE: The roof and sidewall ladders are centered between seams. When placing the roof panel, the
outside edge is bent down. This edge is to be placed on the outside of other roof panel to form a tight seal.
(See Figure 7C on Page 27.) Be sure to apply two (2) strips of caulking on all seams. Assemble roof panels
in a counterclockwise manner.
Figure 7A
On bins that will be equipped with a pneumatic fill system (See Page 81) , the two (2) roof panels with fill
hole and exhaust hole must be located opposite each other on the Bulk Feed Tank.