Chain loop torque arm repair kit – Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1727 User Manual
Page 3
Advertising
PNEG-1727
Page 3 of 4
Chain Loop Torque Arm Repair Kit
Attach the torque plate anchor bracket to the torque plates using the two (2) 1/2" flat washers, shoulder
bolt and 3/8"-16 nylock nut.
Tighten the hardware attaching the torque plate assemblies to the gear reducer after tightening the
shoulder bolt hardware.
Figure 4
Move the torque plate anchor bracket on the square tube so the torque plate assemblies are aligned
vertical. Once aligned, the 3/8"-16 hardware attaching the torque plate anchor bracket to the C-clamp can
be tightened.
NOTE: Washers must be on the outside of each torque plate assembly.
Figure 5
Advertising