Grain Systems PNEG-1711 - Manual (Page 11)

PNEG - 1711
Page 11 of 22 06/30/2009
Digital Thermostat Owner’s Manual
Figure 1 - Drill Pattern
5. Before mounting the GSI moisture control to the panel door, attach the necessary wiring. Be sure to kill power
when installing. Table 1 depicts the relation between the Honeywell controller and the GSI moisture control.
Refer to Figure 2 and Figure 3 for connections of the GSI moisture control. For example, if a wire is attached
to the connection labeled “1” on the Honeywell controller, that wire would need to be attached to “A1” on the
GSI moisture control. Remove the four Phillip head screws from the corner of the controller to access the
connections on the GSI controller.
Table 1 - Honeywell to GSI relation
Honeywell
Connection #
GSI
Connection #
1 A1
2 A2
4 B3
5 B4
8 B1
9 B2