Grain Systems PNEG-1711 User Manual
Page 3
PNEG - 1711
Page 3 of 22
06/30/2009
Digital Thermostat Owner’s Manual
8. Set pressure regulator to avoid excessive gas pressure applied to a burner during ignition and when burner is
in operation. See page 19 for operating gas pressures. Do not exceed maximum recommended drying
temperatures.
9. Do not operate the dryer if any gas leak is detected. Shut down and repair before further operation.
10. Clean grain is safer and easier to dry. Fine material can be highly combustible, and it also requires removal
of extra moisture.
11. Use CAUTION in working around high-speed fans, gas burners, augers, and auxiliary conveyors which can
start automatically.
12. Be certain that capacities of auxiliary conveyors are matched to dryer auger capacities.
13. Do not operate in an area where combustible material will be drawn into the fan.
14. The operating and safety recommendations in this manual pertain to the common cereal grains as indicated.
When drying any other grain or products, consult the factory for additional recommendations.
15. Routinely check for any developing gas plumbing leaks. Check LP vaporizer for contact with burner vanes.