Grain Systems Bin Accessories PNEG-1652 - Manual (Page 12)

3. Inside Ladder Instructions
12 PNEG-1652 Reinforced Inside Ladder Instructions
Inside Ladder Bottom Bracket
The bottom ladder section may need to be cut off if the length is too long. Cut the bottom section at least
12" from the bottom of the floor. Attach the bottom inside ladder brackets (LDR-5133) to the last ladder
section using the six (6) holes per ladder rail. You may need to drill out the holes in the last ladder section
with a 3/8" drill bit. You will also need to drill two (2) 3/8" holes through the sidewall to attach each bottom
bracket to the sidewall. Use 5/16" hardware at all attachment points.
Figure 3D