Grain Systems PNEG-696 - Manual (Page 15)

1 5
Series 2000 Autoflow Operation
Set-up : Extended
The set-up mode is used to program the
computer with different variables that influence how
the dryer will operate. This mode is accessed by holding
in on the modify button when turning on the control
panel.
SET DATE - Use the increase and decrease
buttons to select the correct day of month. Press the
enter button when the correct day of month is dis-
played.
SET MONTH - Use the increase and decrease
buttons to select the correct year. Press the enter
button when the correct month is displayed.
SET YEAR - Use the increase and decrease
buttons to select the correct year. Press the enterbutton
when the correct year is displayed.
SET HOUR - Use the increase and decrease
buttons to select the correct hour. Press the enter
button when the correct hour is displayed.
SET MINUTE - Use the increase and decrease
buttons to select the correct minute. Press the enter
button when the correct minute is displayed.
AIR SWITCH - Use the increase and decrease
buttons to toggle between enabled or disabled. If
disabled is selected the dryer does not require proof of
airflow before the burner lights. If enabled is selected
the dryer requires proof of airflow to light the burner.
Each time the dryer control power is shut off the
CONTROL SYSTEM
airswitch test defaults to enabled.
LOW LEVEL SWITCH- Use the increase and
decrease buttons to toggle between enabled and
disabled. If the disabled the computer will ignore the
status of the drying chamber low level rotary switch. If
enabled the dryer will monitor the status of the drying
chamber low level rotary switch.
WET TANK SWITCH - Use the increase and
decrease buttons to toggle between enabled and
disabled. If the disabled the computer will ignore the
status of the wet supply rotary switch. If enabled the
dryer will monitor the status of the wet supply rotary
switch.
START FANS WITH HIGH - Determines
whether the drying fan(s) will start with the drying
chamber high level or drying chamber low level rotary
switch. Use the increase and decrease buttons to toggle
between enabled or disabled. In most situations the
fan(s) should be started with the drying chamber low
level rotary switch. If the drying chamber high level
rotary switch is selected to control the starting of the
main drying fan(s) the dry cycle and main drying fan(s)
will not start until grain reaches the drying chamber
high level rotary switch. Again, this mode of operation
is not recommended.
AERATION FAN BYPASS - Allows the
aeration fan to remain running after the dryer has shut
down. Use the increase and decrease buttons to toggle
between enabled and disabled. When the aeration fan
bypass is enabled the aeration fan will remain running
after the dryer has stopped if the aeration switch on the
dryer front panel is placed in the “on” position. When
the aeration fan bypass is disabled the aeration fan
stops with the dryer.