Grain Systems PNEG-297 - Manual (Page 10)

10 PNEG-297 Chi-Town Heater
5. Installation
Heater Installation
1. Install three (3) mounting brackets on fan as indicated by the arrows shown in Figure 5A .
Install loosely.
2. Set heater in place and install four (4) mounting bracket.
3. Level heater and tighten mounting brackets.
4. Attach heater to mounting brackets using 1/4" bolts and nuts.
Figure 5A Heater Mounting Brackets Illustration
Fuel Connection
IMPORTANT: Do not use propane tanks which have previously been used for ammonia unless they have
been purged according to procedures of the National LP Association. Investigate to be sure
that the fuel supply system complies with all local codes for LP gas installations.