Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1043 User Manual
Page 21
21
Series 2 Chain Conveyors
Problem
Cause
Solution
Low capacity
Improper chain speed
Check the shaft RPM
Improper feed
Check the grain level at inlet
Plugging
Check the discharges
Noisy operation
Loose UHMW Paddles
Check all bolts on chain
Bottom or Sides Not Aligned
Check Intermediate Trough Section
joints and make flush
Worn Drive Components
Check oil level and shaft seals
belt misalignment; loose belts
Worn Sprocket
Replace
Return Rail Alignment
Check Rail Alignment
Uneven UHMW
Conveyor Misalignment
Check the conveyor alignment
paddle wear
Sprocket Slipped
Check set screws on sprockets
Return Rail Alignment
Check Rail Alignment
Excessive carry-over
Gates Not Fully Opening
Check the gate operation
Uneven sprocket wear
Worn chain
Replace chain (see pg. 13)
Improper alignment
Check the sprocket alignment
Material carry-over
Check for improper location
into discharge sprocket
of inlet (see pg. 11)
Consult your contractor for added assistance.
Trouble Shooting
Trouble Shooting Guide