Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNOT-454 - Manual

PRODUCT NOTIFICATION
PNOT‐454
GSI GROUP • 1004 E. Illinois St. • Assumption, IL 62510 USA • 888‐GSI‐BINS • Fax: 800‐800‐5329 Page 1 of 15
Date: 9‐15‐11
MODELS: 6 x 6 Distributor Platforms
Platform Clamps
This assembly is designed to be located at any elevation on trunking that is needed to provide access to
other equipment. Determine elevation of platform surface and work from there. Locate all parts required
for assembly by using the chart as shown
in Figure 1 .
Locate all clamp halves (DSP36007), clamp brackets (DSP36016), threaded rods (DSP36008) and
hardware to assemble clamps onto the trunking. Measure the distance between the clamps to assure
proper location for support channels and knee brace attachment. See clamp detail
in Figure 1 for hardware
orientation. Attach one clamp half to the end of each platform support channel using 5/8" hardware
in the top and bottom holes of the bracket. Insert rod through the middle hole in the brackets attached
to the platform support channel. Fasten using 5/8" nut, 5/8" lock washer and two (2) flat washers. Place
brackets with support channels attached around trunking and fasten in place with clamp bracket using
1/2" hardware. Adjust the position of the inside nuts of the rod assembly to allow the clamps to be
tightened onto the trunking.
NOTE: Tighten clamps onto trunking, do not overtighten and collapse the trunking. Position inside nuts
back to the clamp and tighten.
Figure 1