Grain Systems PNEG-1754 - Manual (Page 10)

1. Installation
10 PNEG-1754 Tower Dryer Ladder Installation Instructions
Ladder Assembly (Continued)
2. Assemble the ladder using ladder stiffeners (GT1-0156L-XX and GT1-0156R-XX) as shown
in Figure 1I on Page 11 . Make sure the ladder will extend up by 6' from catwalk floor. Use brackets
(GT1-1531-XX and GT1-1532-XX) to attach the ladder to the catwalk as shown in Figure 1I on
Page 11 . Use one set of ladder brackets (LDR-4314) to attach the ladder to the dryer wall, where
perforated sheets overlap as shown in Figure 1I on Page 11 .
As a rule of thumb, use one set ladder standoffs on every other overlap, unless otherwise shown.
Use one set of ladder stiffeners (GT1-0156L-XX and GT1-0156R-XX) per 4' ladder section and
two (2) per 8' ladder section.
Figure 1H