Cobalt Digital COMPASS 9082 HD_SD Frame Sync - Manual (Page 43)

9082-OM (V4.4) 9082 PRODUCT MANUAL 3-17
Operating Instructions
9082 Function Submenu List and Descriptions
(continued)
• Offset Controls Allows the current timecode count to be advanced or delayed on the
output video.
• Offset Advance or Delay selects offset advance or delay.
• Offset Field delays or advances or delays timecode by one field.
• Offset Frame delays or advances or delays timecode by up to 5
frames.
Note: Default settings are null, with both controls set at zero as shown.
• SD VITC Waveform Insertion Controls For SD output, enables or disables SD VITC waveform timecode insertion
into the output video, and selects the VITC1 and VITC2 line numbers (6
thru 22) where the VITC waveform is inserted.
Note: • Although the output line drop-down will allow any choice within the
6 thru 22 range, the actual range is automatically clamped (limited)
to certain ranges to prevent inadvertent conflict with active picture
area depending on video format. See Ancillary Data Line Number
Locations and Ranges (p. 3-8) for more information.
• The card does not check for conflicts on a given line number.
Make certain the selected line is available and carrying no other
data.
• If only one output line is to be used, set both controls for the same
line number.
• SD ATC Insertion Control For SD output, enables or disables SD ATC_VITC timecode insertion into
the output video, and selects the line number for ATC_VITC.
Note: • Although the output line drop-down will allow any choice within the
9 thru 22 range, the actual range is automatically clamped
(limited) to certain ranges to prevent inadvertent conflict with
active picture area depending on video format. See Ancillary Data
Line Number Locations and Ranges (p. 3-8) for more information.
• The card does not check for conflicts on a given line number.
Make certain the selected line is available and carrying no other
data.
Table 3-2 9082 Function Submenu List — continued