Cobalt Digital COMPASS 9064 Up_Down_Cross Converter - Manual (Page 27)

9064-OM (V4.1) 9064 PRODUCT MANUAL 2-3
Installation and Setup
Installing the 9064 Into a Frame Slot
Note: The 9064 BNC inputs are internally 75-ohm terminated. It is not necessary to
terminate unused BNC inputs or outputs.
Note: External frame sync reference signals are received by the card over a refer-
ence bus on the card frame, and not on any card rear I/O module connectors.
The frame has BNC connectors labeled REF 1 and REF 2 which receive the
reference signal from an external source such as a house distribution.
Note: To remove a card, press down on the ejector tab to unseat the card from the
rear I/O module mating connector. Evenly draw the card from its slot.
10. If network remote control is to be used for the frame and the frame has
not yet been set up for remote control, perform setup in accordance with
Setting Up 9064 Network Remote Control (p. 2-5).
Note: If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.
Figure 2-1 9064 Rear I/O Module Connections
Both the built-in Rear I/O Modules on the 8310-BNC/
8310-C-BNC frames and the optional RM20-9064-A Rear I/
O Module use the connector arrangements shown to the left.
Connect cabling as shown. Unused connectors do not
require external termination.
RM-9064-A.PNG