Cobalt Digital COMPASS 9064 Up_Down_Cross Converter - Manual (Page 63)

9064-OM (V4.1) 9064 PRODUCT MANUAL 3-33
Operating Instructions
9064 Function Submenu List and Descriptions
(continued)
• VITC Waveform Output Line Selects the VITC1 and VITC2 line numbers (6 thru 22) where the VITC
data is inserted.
Note: • Although the output line drop-down will allow any choice within the
6 thru 22 range, the actual range is automatically clamped
(limited) to certain ranges to prevent inadvertent conflict with
active picture area depending on video format. See Ancillary Data
Line Number Locations and Ranges (p. 3-8) for more information.
• The card does not check for conflicts on a given line number.
Make certain the selected line is available and carrying no other
data.
• If only one output line is to be used, set both controls for the same
line number.
• SD VITC Waveform Insertion Control Enables or disables VITC waveform timecode insertion into the SD-SDI
output stream.
• SD ATC Insertion Control For SD output, enables or disables ATC_VITC timecode insertion into the
video stream.
Note: SD ATC_VITC is locked to line 12. The card does not check for
conflicts on a given line number. Make certain this line is available if
SD ATC_VITC is to be used. See Ancillary Data Line Number
Locations and Ranges (p. 3-8) for more information.
• HD ATC_VITC Insertion Control For HD output, enables or disables ATC_VITC timecode insertion into the
video stream.
• HD ATC_VITC Line Insertion Controls For HD ATC_VITC timecode output, selects the line number for
ATC_VITC1 and ATC_VITC2.
Note: • Although the output line drop-down will allow any choice within the
8 thru 20 range, the actual range is automatically clamped
(limited) to certain ranges to prevent inadvertent conflict with
active picture area depending on video format. See Ancillary Data
Line Number Locations and Ranges (p. 3-8) for more information.
• The card does not check for conflicts on a given line number.
Make certain the selected line is available and carrying no other
data.
• If only one output line is to be used, set both controls for the same
line number.
• HD ATC_LTC Insertion Control For HD output, enables or disables ATC_LTC timecode insertion into the
video stream.
Table 3-2 9064 Function Submenu List — continued