TC Electronic FireworX - Manual (Page 12)

INTRODUCTION Setups
10
Setup
The FireworX can be used in a number of applications. Therefore we present a couple of suggestions on how to
connect the FireworX.
Send/Return
Connect the auxiliary out from your mixing console to the left or right input of
the FireworX. Connect the FireworX left/right outputs to the auxiliary return or
two channels on your mixing console. This leaves the one input open to be used
as Vocoder or Ring Modulator Carrier input.
Group insert
Connect the left/right insert send from your subgroups to the FireworX
left/right input.
Connect the FireworX left/right outputs to the subgroups insert return. This
setup makes it possible to mix several sources through the FireworX, and a
master or group effect to the sources.
Insert External Device
When using the Analog In/Outs of the FireworX, the Insert Loop makes it
possible to connect an external device to the Digital In/Outs or vice versa. The
Send and Return point of the Insert is set up in the Effects Routing menu.