TC Electronic FireworX - Manual (Page 39)

37
MODIFIERS Modifier
Fine Tune - Shifts the generated frequency in increments of
cents.
Range: +/- 50 cents.
Quantize into semitones - Makes the function approximate to the
semitone nearest to the incoming control value.
Feed 2 Pitch Bend - Feed 2 of the Function is used as Pitch
Bender. This parameter sets whether neutral position of the Pitch
Bender is “Null” or “Center” e.g. using a keyboard bender would
in most cases use the Center position as neutral.
Note to Resonator Freq
The “Note to Resonator Freq” Type converts control values to
Resonator notes. This can be used to convert Pitch Detector or
MIDI note information to Resonator notes.
Example 1:
Connect the Pitch detectors output to Function 1, Feed 1 in the
Modifier Matrix. Connect the output of the Function to the input
of a “Freq” parameter of the Filter, Resonator or Resochord.
The Resonator will now follow the pitch of the incoming source
material.
Example 2:
Set up Ext 1 to be controlled by MIDI Note-On-key. Connect the
output of Ext. 1 to Function 1, Feed 1. Connect the output of the
Function to the input of a “Freq” parameter of the Filter,
Resonator or Resochord. The Resonator can now be controlled
by an external keyboard.
Feed 2 is used for Pitch Bender control.
Transpose - Shifts the generated note increments of semitones.
Range: +/- 48 Semitones.
Fine Tune - Shifts the generated note in increments of cents.
Range: +/- 50 cents.
Quantize into semitones - Makes the function approximate to the
semitone nearest to the incoming control value.
Feed 2 Pitch Bend - Feed 2 of the Function is used as Pitch
Bender. This parameter sets whether neutral position of the Pitch
Bender is “Null” or “Center” e.g. using a keyboard bender would
in most cases use the Center position as neutral.