TC Electronic FireworX - Manual (Page 55)

53
RESONATOR
Resonator Voice 1-4*
These parameters adjust the length of the four delays and
thereby change the resonant frequencies.
Range: 55Hz-1750Hz.
Feedback Voice 1-4*
The Feedback adjusts the resonance of the resonators.
The feedback of the resonators is preadjusted, but these
feedback parameters allow you to customize them for your
purpose. Note that negative feedback produces different
harmonics than positive.
Filter placement 1-4
These parameters switch the high and low cut filter and
levels to be placed before or after the resonators.
Locut Voice 1-4*
Cuts off frequencies lower than the selected frequency on the
Vocal input. The slope of the filter is 12dB/octave.
Range: 10Hz-16kHz.
Highcut Voice 1-4*
Cuts off frequencies higher than the selected frequency. The
filter is relative to the Frequency of the corresponding
Resonator voice. The slope of the filter is 12dB/octave.
Range: 0-100%.
Levels Voice 1-4*
Sets the level of each of the four resonators.
Panning Voice 1-4*
Sets the panning of each of the four resonators.
Mix*
Mixes between direct sound and effect.
In Level*
Controls the input level of the block.
Out Level*
Controls the output level of the block.
THE BLOCKS
NOTE: The peak of the filters can get very loud and can
easily hit the internal ceiling and thereby cause distortion.
To prevent that, turn down the input level of the Filter block.
Resochord
The Resochord is based on the same algorithm as the
Resonator. However, in the Resochord the four resonators
are scaled within chords. All you have to do is change the
master frequency to tune the chord in the key you desire.
The parameters available in the Modifier Matrix are marked
with an asterisk*.
RESOCHORD
Freq*
The master frequency, tuning the four resonators to one base
key simultaneously.
Chord
Sets the four resonators up in various chord relationships.
Choose between: Major, Major 6th, Major 7th, Major Maj
7th, Minor, Minor 6th, Minor 7th.
Feedback Voice 1-4*
The Feedback adjusts the resonance of the resonators.
The feedback of the resonators is preadjusted, but these
feedback parameters allow you to customize them for your
purpose.
Filter placement Voice 1-4
These parameters switch the high and low cut filter and
levels to be placed before or after the resonators.
Locut Voice 1-4*
Cuts off frequencies lower than the selected frequency. The
slope of the filter is 12dB/octave.
Range: 10Hz-16kHz.
Highcut Voice 1-4*
Cuts off frequencies higher than the selected frequency. The