TC Electronic FireworX - Manual (Page 59)

57
THE BLOCKS
RING MOD. EXTERNAL
Carrier Chnl
The Carrier channel parameter swaps the Left/Right inputs
Vox/Carrier connection.
Lower/Upper band balance*
Controls the relationship between the upper (freq 1 + freq 2)
and the lower (freq 1 - freq 2) sideband. A fifty fifty mix
equals the sound of a traditional ring modulator.
Output Pan*
Controls the panning of the Ring Modulator output.
Carrier AGC
Switches the Automatic Gain Control on the Carrier input
on/off.
In 1 and 2 Locut*
Cuts off frequencies lower than the selected frequency on the
two inputs. The slope of the filter is 12dB/octave.
Range: 10Hz-16kHz.
In 1 and 2 Highcut*
Cuts off frequencies higher than the selected frequency on
the two inputs. The slope of the filter is 12dB/octave.
Range: 10Hz-16kHz.
Low/Up Locut*
Cuts off frequencies lower than the selected frequency on the
Lower and Upper sideband. The slope of the filter is
12dB/octave.
Range: 10Hz-16kHz.
Low/Up Highcut*
Cuts off frequencies higher than the selected frequency on
the Lower and Upper sideband. The slope of the filter is
12dB/octave.
Range: 10Hz-16kHz.
Mix*
Mixes between direct sound and effect.
In Level*
Controls the input level of the block.
Out Level*
Controls the output level of the Ring Modulator block.
Ring Mod. Internal
This variation of the FireworX Ring Modulator provides an
internal carrier sine wave generator with user controllable
frequency. That means that the left and right input of the
block is summed together and used as control input. The
parameters available in the Modifier Matrix are marked with
an asterisk*.
RING MOD. INTERNAL
Carrier*
Sets the frequency of the internal carrier sine wave
generator. Range: 2Hz - 2kHz.
Lower/Upper band balance*
Controls the relationship between the upper (freq 1 + freq 2)
and the lower (freq 1 - freq 2) sideband. A fifty fifty mix
equals the sound of a traditional ring modulator.
Output Pan*
Controls the panning of the Ring Modulator output
In Locut*
Cuts off frequencies lower than the selected frequency on
the input channel. The slope of the filter is 12dB/octave.
Range: 10Hz-16kHz.
In Highcut*
Cuts off frequencies higher than the selected frequency on
the input channel. The slope of the filter is 12dB/octave.
Range: 10Hz-16kHz.
Low/Up Locut*
Cuts off frequencies lower than the selected frequency on
the Lower and Upper sideband. The slope of the filter is
12dB/octave.
Range: 10Hz-16kHz.
Low/Up Highcut*
Cuts off frequencies higher than the selected frequency on
the Lower and Upper sideband. The slope of the filter is
12dB/octave.
Range: 10Hz-16kHz.
Mix*
Mixes between direct sound and effect.