TC Electronic Broadcast 6000 - Manual (Page 62)

VSS™ SR
58 System 6000 MKII Algorithms
Mid Xover
Range: 200 Hz to 2 kHz
Sets the frequency at which the transition from
the low-mid to the mid frequencies takes place.
Hi Mid Decay
Range: 0.01 to 2.5
The Ratio control multiplier for the Hi-mid fre-
quencies.
Hi Xover
Range: 500 Hz to 20 kHz
Sets the frequency at which the transition from
the mid frequencies to the high frequencies
takes place.
Hi Decay
Range: 0.01 to 2.5
Multiplier for the frequencies above the Hi Xover
frequency. Example: If the main Decay param-
eter is set to 2.0 sec and the Hi Decay parameter
is set to 1.5, frequencies above the Hi-Xover will
decay for 3.0 sec. Conversely if this parameter
is set to 0.5 the Decay time above the Hi Xover
point will be 1 sec.
Rev Depth
Range: Center, Stereo, Deep
With this parameter you can change the per-
ceived Depth of the Reverb.
VSS™ SR algorithm – mod page
VSS™ SR algorithm – mod page
Reverb Modulation
RevMod Type
Range: Off, Smooth 1, Smooth 2,
Perc, Wow, Vintage, Wild.
Selects the type of modulation.
RevMod Rate
Range: -100, default, +100
Allows you to offset the speed of the LFO from
the factory default assigned to each Type.
RevMod Width
Range: 0 % to 200 %
Sets the Width of the modulation.
Space Modulation
This group of parameters sets the way the sound
moves about the room.
SpcMod Type
Range: Off, Normal, Fast, Slow, MidFreq, Sync.
Selects the Type of Modulation.
SpcMod Rate
Range: -100, default, +100
Allows you to offset the speed of the LFO from
the factory default assigned to each type.
SpcMod Width
Range: 0 % to 100 %
Sets the width of the modulation.
SpcMod Depth
Range: -50, default, +50
Allows you to offset the amount of space modu-
lation from the factory default.