4 software break points, 5 limitations of debugwire, 6 register description – Rainbow Electronics ATtiny43U User Manual

Page 132: 1 dwdr – debugwire data register, Attiny43u

Advertising
background image

132

8048B–AVR–03/09

ATtiny43U

When designing a system where debugWIRE will be used, the following observations must be
made for correct operation:

• Pull-Up resistor on the dW/(RESET) line must be in the range of 10k to 20 k

Ω

. However, the

pull-up resistor is optional.

• Connecting the RESET pin directly to V

CC

will not work.

• Capacitors inserted on the RESET pin must be disconnected when using debugWire.

• All external reset sources must be disconnected.

17.4

Software Break Points

debugWIRE supports Program memory Break Points by the AVR Break instruction. Setting a
Break Point in AVR Studio

®

will insert a BREAK instruction in the Program memory. The instruc-

tion replaced by the BREAK instruction will be stored. When program execution is continued, the
stored instruction will be executed before continuing from the Program memory. A break can be
inserted manually by putting the BREAK instruction in the program.

The Flash must be re-programmed each time a Break Point is changed. This is automatically
handled by AVR Studio through the debugWIRE interface. The use of Break Points will therefore
reduce the Falsh Data retention. Devices used for debugging purposes should not be shipped to
end customers.

17.5

Limitations of debugWIRE

The debugWIRE communication pin (dW) is physically located on the same pin as External
Reset (RESET). An External Reset source is therefore not supported when the debugWIRE is
enabled.

The debugWIRE system accurately emulates all I/O functions when running at full speed, i.e.,
when the program in the CPU is running. When the CPU is stopped, care must be taken while
accessing some of the I/O Registers via the debugger (AVR Studio). See the debugWIRE docu-
mentation for detailed description of the limitations.

A programmed DWEN Fuse enables some parts of the clock system to be running in all sleep
modes. This will increase the power consumption while in sleep. Thus, the DWEN Fuse should
be disabled when debugWire is not used.

17.6

Register Description

The following section describes the registers used with the debugWire.

17.6.1

DWDR – debugWire Data Register

The DWDR Register provides a communication channel from the running program in the MCU
to the debugger. This register is only accessible by the debugWIRE and can therefore not be
used as a general purpose register in the normal operations.

Bit

7

6

5

4

3

2

1

0

0x27 (0x47)

DWDR[7:0]

DWDR

Read/Write

R/W

R/W

R/W

R/W

R/W

R/W

R/W

R/W

Initial Value

0

0

0

0

0

0

0

0

Advertising