4 gps antenna power supply, 8 operating mode configuration – Rainbow Electronics MG260 User Manual
Page 52
![background image](/manuals/281828/52/background.png)
MG260 Product Specification
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without prior written
agreement.
2.7.4 GPS antenna power supply
A voltage input is available on the System Connector in order to supply a GPS
active antenna connected to the MG260 module.
This power supply DOES NOT need to be protected, since the protection is
already embedded in the module.
Pin description
Signal
Pin #
I/O
I/O type
Description
GPS_VANT
18
I
Supply
GPS antenna external supply
e If 5V Antennas are used, it is necessary to provide 5V on this pin.
e If 3V antennas are used, it is necessary to provide 5V on this pin.
2.8 Operating mode configuration
Operating
mode
VBATT
(input signal)
GPS_EN
(input signal)
ONKEY
(output signal)
Module OFF
Low
Low
Low
GSM/GPRS only
High
Low
High
GPS only
High
High
Low
GSM/GPRS/GPS
High
High
High