BabyTrend 8665 - TREND HIGH CHAIR - ORANGE OAK - Manual (Page 7)

Copyright © 2007 - 2008, Baby Trend Inc., All Rights Reserved.
Fig. 9
Fig. 10
Hole
Hole
Push
Buttons
Hole
Push
Buttons
5
8. Insert the Legs into the ends of the front
tube of both the right and left Upper Frame
Assemblies (Fig. 9). Note: Legs are properly
connected when the push buttons are lined up
with the holes on the ends of the Upper Frame
Assembilies. Make sure the push buttons are
engaged before use.
9. Insert another Leg into the ends of the rear
tube of both the right and left Upper Frame
Assemblies (Fig. 10).
10. Attach each of the Casters to the high chair
feet as shown in Figure 11. Snap casters into
Bottom of the foot. Check that all four Casters
are securely fastened to the High Chair.
11. Flip over Tray to attach Crotch Retainer. The
molded plastic housing must be oriented by
facing the slot toward front of the Tray. Insert
the 4 (3.5mm X 10) Screws and tighten.
DO NOT OVER-TIGHTEN (Fig. 12).
Fig. 11
ASSEMBLY
Fig. 12