BabyTrend 8665 - TREND HIGH CHAIR - ORANGE OAK - Manual (Page 8)

Copyright © 2007 - 2008, Baby Trend Inc., All Rights Reserved.
6
TO ATTACH SEAT PAD
NOTE: Certain High Chair models are packaged
with the High Chair Seat Pad and Seat Insert
already attached to the Seat Back. If your model
has a Seat Pad and Seat Insert on the Seat Back
please skip ahead to Step 2.
1. Loop the flap on the back of the pad over the
top of the Seat Back. Connect the Seat Pad
to the Seat Back with the two Elastic Loops.
These fit over the Attachment Tabs located near
the top harness slots (Fig. 13).
2. Attach the bottom of Seat Pad to the Seat Base
with the two Elastic loops located at the rear of
the bottom of the Seat Pad. These fit over the
Attachment Tabs located on the Seat Base near
where the Seat Back and Seat Base Join.
(Fig. 14)
3. Set Seat Insert onto Seat Pad.
4. Thread non-buckle end of Harness Straps
called Harness Attachment Tabs through the
provide slots in the Seat Fabric, Seat Insert,
Seat Back, and Seat Base (Fig. 15). When
Harness Attachment Tabs are through the
provided slots, rotate the Harness Attachment
Tabs 90 degrees. Make sure that the straps are
firmly in place.
TO REMOVE SEAT PAD
Reverse steps above.
ASSEMBLY
Fig. 13
Fig. 15
Fig. 14