American Car Craft Corvette Inner Fender Liner Polished Component 8Pc 2005-2013 C6+GS - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
C6 CORVETTE COMPONENT FENDER LINER KIT 8PC
PART#043021
patent pending
PLEASE TAKE THE TIME TO READ AND UNDERSTAND THE ENTIRE
INSTRUCTIONS BEFORE BEGINNING THIS INSTALLATION.
PARTS INCLUDED:
___8-Stainless Fender Liners
___4-Adhesive Promoter Packs
___2-Chrome Sensor Covers w/butyl putty SMALL #115NC LARGE #126NC
___1-Small Zip Tie
Your new accessory comes to you with a clear protective liner. This liner will help to
keep your new parts clean during installation. You will be instructed when to remove the
liner during the detailed installation.
1. The first step will be to thoroughly clean both of the top areas along the entire
length of the inner fenders, the out crop just below the hood prop shock and also
the small triangle looking area just behind the hood catch mechanism with
household rubbing alcohol to remove any and all road grime and dirt. Once
completely clean swipe these areas with the adhesive promoter provided. This
will create a nice permanently bondable surface for your new liners to attach to.
2. In order to check the fitment and prepare for installation you will need to
rearrange a couple of things in the inner fender area to make room for your new
parts. Starting with the passenger side you will notice looking down over the fuse
box the passenger side hood release cable and aluminum A/C service port sensor
line. (SEE PICTURE #1) These two items will need to be relocated, in order to do
this you will need to remove the two 10mm nuts to the left and right sides of the
fuse box. The fuse box has one more 7mm screw just behind the tire inside the
wheel well that you will also need to remove.
3. Now that the fuse box has been unfastened pull up on the box to move it out of
the way temporarily. You will notice that there is a heavy wire harness attached