American Car Craft Corvette Inner Fender Liner Polished Component 8Pc 2005-2013 C6+GS - Manual (Page 3)

tightly in position pull the red liner off the attachment tape as you firmly press the
cap cover to set.
8. You have been supplied with a small triangular cover to be placed just behind the
hood catch mechanism. Simply peel the red release liner completely off and set
into position, press firmly.(SEE PICTURE#16)
9. You have been supplied with a longer triangular section to be mounted to the
front outcrop area just under the hoods prop shock.(SEE PICTURE#17) Detach
the hood prop shock to allow an easier placement of this next part. Place the
stainless section in position. You will notice that the new fender liner mounted
earlier has a triangular section cut from it. Allow this small cover to set against
the outcrop and sit just inside the cut out. As you place it in position you will see
just how it will want to sit. Make any adjustments to the shape of this small cover
to achieve this placement. Once you are satisfied with the fit simply remove the
red release liner from the back of the part and reposition pressing firmly to set
then reattach the hood prop shock. (SEE PICTURE#18)
10. You have been provided with two chrome A/C line service port and sensor
covers. (SEE PICTURE#19) In order to install the larger sensor cover you will
need to streamline the electrical connection. Remove the grey plastic wire
separator. (SEE PICTURE #20) Peel back the black wire loom and trim it down
the base of the sensor. Be sure to leave enough to protect the wires from the liners
edge.(SEE PICTURE#21) Slice the electrical tape off the three wires so that you
can now reposition each of the three wires down the length of the sensor
separately. Band the wires to the sensor with the small zip tie provided and snip
the excess tie off. You will notice that the large cover has two spots of butyl
inside the cover.(SEE PICTURE#22) Arrange the cover so that the two spots can
be pushed over the sensor in such a way that the butyl will attach the cover in a
nice straight vertical position. The smaller cover attaches with butyl in just the
same way. Simply push it onto the service port. (SEE PICTURES#23,#24,#25)
11. The drivers’ side cover installs in much the same way only you will need to
detach the hood prop shock in order to allow you to manipulate the cover under
the water tank and over the lower tank hose.
12. Remove protective liners from entire installation.
13. TECH TIP: If you are planning to install our stainless brake booster cover, this
cover will need to be installed first as it requires you to detach the water tank for