American Car Craft Challenger Trunk Lid Liner Polished 2008-2013 all - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
Challenger Polished Trunk Lid Panel
PART #151029
Parts Included:
1-Stainless Trunk Panel
8-Small Pan Head Self Tapping Screws
8-Chrome Screw Cap Covers w/White Sockets
Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in
place until the installation is complete to prevent finger prints and or possible scratches during installation.
1. Remove the trunk s deck lid insulator pad if so equipped.
2. Remove the wire harness from its attachment points and remove all the retainers securing the harness
both from the harness and or the deck lids sub frame. The idea here is to eliminate any and all
obstructions that may impede the new panel to sit flush to the deck lids sub frame.
3. Carefully tape down the harness to lead out to the new panel harness exit notch at the right of the
panel. You will need to set the panel closely into the deck lid to determine just the right spot to tape