American Car Craft Corvette Side Marker Trim Rear 2Pc with Corvette script Polished 1997-2004 C5 & Z06 - Manual (Page 2)

3. The next step will be to install the chrome trim. Apply a single bead of adhesive
promoter tube (provided) along the outer edge of the factory lens. Make sure that
the end of the chrome trim is nice and square. Pull the red release liner from the
back of the trim and set it at the very bottom center of the factory red lens and
work the trim around the lens at the same time try to set the trim tightly against
the stainless cover. When you reach the start point mark that point by pressing
your finger nail into the trim, doing this will give you an excellent indication
where to cut the excess. Apply a tiny drop of an instant adhesive to the edge of the
trim and then set the two ends together pressing firmly to set the entire length of
the trim.
DO NOT GET WET FOR 24 HOURS.
IF ANY QUESTIONS OCCUR DURING INSTALLATION PLEASE CONTACT
AMERICAN CAR CRAFT AT 727-861-1500.
Thank You and Enjoy Your New Purchase.
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com