American Car Craft Challenger 5.7 Engine Shroud Trim Kit Polished 5.7L 2008-2013 14Pc(Now 17Pc) - Manual (Page 2)

swipe the ribs once with the adhesive promoter tube (provided). REPEAT this same
process for the LARGE CENTER SECTION and 5.7L V8 where you will be
applying your stainless cover and letters.
2. Place the stainless steel center piece into place and make note of its position. It
may be necessary to slightly form by hand so that it CONFORMS to the shape of
the factory shroud and lies FLAT WITHOUT FORCING. (This piece should be
shaped to your cover so that it looks like it has been installed before you remove the
red liner. It may be necessary to form by hand a few times until you achieve a nice
proper fit.) Once you are satisfied with the fit remove the red liner and reposition on
shroud. Press firmly to set. Repeat this same process for the lettering.
3. Looking at the piece that you just installed, starting at the very center of the rear
of the engine cover apply the trim directly to the beveled edge on the FACTORY
SHROUD NOT ON THE STAINLESS COVER place the long chrome trim molding
(removing the red liner as you go) and work your way around the perimeter of the
center piece until you reach your start point. Cut the excess molding slightly longer
and force the molding into a tight butt seam. Press firmly to set along the entire
perimeter. Remove protective liner.
4. Place the 3 chrome engine shroud trim strips starting on the passenger side from
the front most forward part of the rib and work it along the rib as straight as
possible. Press firmly to set. Repeat this process until all 3 strips are installed. Next
place the 3 chrome strips the same way on the drivers’ side. NOTE: These strips will
cross the oil hole opening, continue to lay the molding across the oil filler hole
opening to the rear of the cover. Once complete use a straight razor to cut the excess
molding over the opening and remove.
If you have used any products to make your engine cover "shine" you will need to
make an extra effort in cleaning and preparing the surface for installation.
Returns are allowed only for parts with manufacturing defects. Installation errors
are not manufacturing defects and parts can not be returned do to improper
installation.
If any questions occur during installation, please contact American Car Craft at
727-861-1500.
Thank you and enjoy your new purchase.
Note: Care must be taken when cleaning your cover. It is a good idea to lightly dust
your cover with a clean soft cloth first in order to prevent any particles from
scratching it. Then wipe (using a new clean soft cloth) with a good quality streak
free glass cleaner.