American Car Craft Corvette Door Guards Brushed with Black Flames 2Pc 2005-2013 C6 - Manual (Page 2)

PLEASE READ ALL INSTRUCTIONS BEFORE
BEGINNING YOUR INSTALLATION! YOU
MUST FOLLOW THESE INSTRUCTIONS
EXACTLY OR YOUR NEW PANELS MAY NOT
ADHERE.
1. BEFORE YOU BEGIN YOU MUST FIRST PREP THE DOOR PANEL IN
ORDER TO ALLOW ADHESION!!!!. You can do this by scrubbing the
entire area first with household isopropyl alcohol. Then closely follow the
procedures outlined in the following steps!!!!
2.
If your door panels have been treated with armor-all or silicone
coatings, installation will NOT work unless these treatments have
been REMOVED with special chemicals! Household Isopropyl
alcohol alone WILL NOT remove it.
NOTE: Some doors have
been treated at the dealerships and the factory
before you purchased the car
. So to be extra
safe we suggest that you please refer to
the SPECIAL PREPARATION
INSTRUCTIONS enclosed. We can not be
responsible for
panels’ not sticking due
to improper door preparation!
3. NOTE: YOU HAVE BEEN PROVIDED WITH A SMALL ABRASIVE PAD
AND 2 TEST STRIPS ONE FOR EACH DOOR.
4. Apply a strip of masking tape along the door panel above the contour to
protect it. Lightly scuff the door panel along the entire perimeter to be
mounted and wipe off any and all shavings. This step will produce a raw
surface. Once this is done swipe the entire perimeter with the adhesive
promoter (provided). Allow a few seconds to dry. Use one of the test
strips provided to test tackiness of the door panel area to be mounted. If
all the procedures from the SPECIAL PREPARATION INSTRUCTIONS
have been preformed properly your test strip will stick. If it does not stick
perform the entire preparation again until it does.
DON’T ATTEMPT TO