American Car Craft Corvette Door Guards Brushed with Black Flames 2Pc 2005-2013 C6 - Manual (Page 3)

INSTALL YOUR DOOR GUARDS UNTIL YOUR TEST STRIPS ADHERE
PROPERLY.
Installation errors are NOT manufacturing
defects and parts
CANNOT be returned
due to improper installation.
Before you remove the red liner for permanent attachment place the door
guard into position and check the fit. Your panel comes to you preformed
however it will be necessary to form by hand to insure a nice perfectly
contoured fit. When you are holding the panel up to the door it
should lay flat and conform to the shape of the door without forcing
it. (In other words it should look like it is installed and not be protruding
from the door panel in any way). Please refer to the pictures at the end of
these instructions. Make note of its position. NOTE: Be sure that the points
tuck into the door panel and do not protrude. PLEASE NOTE: Metal will not
bend out of place itself so if it is properly formed and installed the panels will
remain in place.
5. Remove the red liner (be sure not to touch the adhesive) and carefully
reposition the door guard, press firmly on the panel to set.
6. Remove protective liner. Then repeat steps 1-7 for the other door.
If any questions occur during installation please contact American Car
Craft @ 727 861-1500.
Thank you and enjoy your purchase!
Note: Care must be taken when cleaning your door guards. It is a good
idea to lightly dust your door guards with a clean soft cloth first in order to
prevent any particles from scratching them. Then wipe (using a new clean
soft cloth) with a good quality streak free glass cleaner.
This is how your installed panels are designed to fit on your door panel.
American Car Craft LLC
18924 Sakera Rd Hudson, FL. 34667
Ph 727.861.1500 Fax 727.861.1520
www.americancarcraft.com