R&M Materials Handling ELECTRIC CHAIN HOISTS LoadMate Chain Hoist LM 1 - Manual (Page 29)

LM01 I&M MANUAL/EN/11.30.2010
29/65
This document and the information contained herein, is the exclusive property of R&M MATERIALS HANDLING, INC. and represents a non-public, confidential and proprietary trade secret
that may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M MATERIALS HANDLING, INC.
Copyright © (2010) R&M MATERIALS HANDLING, INC. All rights reserved.
5.6 Chain Container
Figure 9. Chain Container Installation
m
CAUTION: Chain container must be installed for effective operation of travel limit switch.
Removing Chain Container
1. Remove clip (item 3) from end of pin (item 2).
2. Pull pin (item 2) out while supporting chain container (item 1) at same time.
3. Remove chain container.
Installing Chain Container
1. Insert load chain into chain container (item 1) and position chain container on mounting bracket.
2. Align holes and insert pin (item 2) through chain container (item 1) and mounting bracket.
3. Secure with two clips (item 3), one on each end of pin (item 1).