Derale Performance 14" Dyno-Cool Electric Fan and Mechanical Fan Controller Kit, Premium - Manual (Page 2)

Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
Warning: Installation of accessories should only be undertaken by those with mechanical knowledge and are familiar with working on
vehicles. Always use eye protection (goggles, safety glasses or shield). Park the vehicle in a well lit area, on level ground and apply the
parking brake. Only work on a cold vehicle that has been sitting overnight, failure to do so will result in severe burns and injury. Before starting
the vehicle, make sure no tools or any other items are left under hood that could interfere with or be drawn into moving parts of the engine.
Failure to follow instructions can lead to severe damage and personal injury.
THERMOSTAT PROBE INSTALLATION
Making sure the vehicles engine is cold; drain enough coolant out of the
radiator so the upper radiator hose can be removed.
Coolant is a hazardous fluid, drain into container. Never open Warning:
radiator cap or attempt to remove hose while motor is hot.
1. Remove radiator clamp and hose.
2. Insert thermostat probe into radiator hose. (See Diagram #5)
3. Place capillary tube on radiator inlet tube so the probe itself will remain
positioned in the hose. Place the foam pad between the capillary tube
and the radiator inlet tube. (See Diagram #5)
4. Carefully install radiator hose and tighten hose clamp.
It is recommended that a screw type hose clamp is used for Note:
correct sealing (See Diagram #6). Factory type clamps can leak.
5. Double check coolant level, fill as required.
WIRING
1. Disconnect the Negative (-) terminal on the vehicles battery.
2. Using the #10 Blue Ring Terminal provided, attach the Negative (-) electric fan lead to a good Chassis Ground (-).
3. Using the extra Wire, Blue Female Connector, 30 Amp Fuse Holder and Blue Butt Connectors provided, attach the
Positive (+) electric fan lead to the RIGHT terminal on the Thermostat Switch. (See Diagram #7)
4. Using the extra Wire, Blue Female Connector and Blue Wire Tap Connector provided, attach the LEFT terminal on the
Thermostat Switch to a 12V Positive (+) Switched Ignition Source.
5. Reattach the Negative (-) terminal on the vehicles battery.
ADJUSTING THE TEMPERATURE
Adjustment range is 32°F to 240°F
Higher turn-on temperature: Turn the adjuster clockwise.
Lower turn-on temperature: Turn the adjuster counter clockwise.
Adjust the thermostat to desired setting by turning the brass
adjuster with a flathead screwdriver.
Note: Knob not included.
Diagram #6 Diagram #5 Diagram #5
1 1/2” x 1 1/2”
Foam Pad Radiator
Inlet Tube
Capillary
Tube
Probe
Hose Clamp
Radiator
Hose
Diagram #4
Thermostat
Switch
Capillary Tube
to Probe
M4-0.7
Philips
HeadBolts
#10 Sheet
Metal Screws
Mounting
Bracket
Positive (+)
Fan Wire
Chassis
Ground
Diagram #7
THERMOSTAT SWITCH MOUNTING
1.
Using the two M4-0.7 Philips Head Screws, attach the Mounting Bracket to
the Thermostat Switch. (See Diagram #4)
2. Locate the Thermostat Switch in an accessible location near the radiator
inlet hose.
Note: The Capillary Tube Probe Cannot be lengthened or cut in any way.
3.
Using the Mounting Bracket as a guide, mark and drill two 5/32” holes.
4. Using the two #10 Sheet Metal Screws provided, attach the Thermostat Switch.
12V (+)
Switched
Ignition Source
Negetive (-)
Fan Wire
Thermostat
Switch