Vonnic C909IP H.264 Wireless 802.11b_g_n IP Network Camera - Manual (Page 13)

H Series IP Camera User Manual – with Pan/Tilt of CMOS
13
you it is recording. Click the “Record” button again, and then the record stops.
5.2.6 Playback
Click “Playback” button, it will pop up a player which could play the video stored on your PC
disk.
Figure 12
, these buttons are for play, stop, the previous recorder, the next
recorder, open the recorder file. Please click the button of “open the recorder file” first,
and select the file you want to play, you can playback the recorder.
5.2.7 The control of Pan/Tilt
At the control area of Pan/Tilt, the user could control the cruise of the Pan/Tilt by the
arrowhead direction (Up/Down/Left/Right/Centre/Stop/Left-right cruise/Up-down cruise).
When your mouse stops on these control buttons, it will guide you what this button mean.
When the IP Camera turns to some position, you can click the “Set” Button, when you
continue to control the Pan/tilt to turn to other position, y ou could click the “Call” button, the
Pan/Tilt will go back the pre-position.
5.3 Notice (for the first time use)
Please change the following 2 settings when using for the first time:
1) Please refer to the content of part 7.4.1 to change the initial passwords of admin, user,
and guest. Their initial passwords are respectively “123456”, “user”, “guest”.
2) Refer to the content of part 7.5.1 to set the system time.
6 Visit IP Camera from WAN
6.1 Port forwarding
Follow the “Visit IP Camera from LAN” steps; make sure PC-1 can visit IP Camera-1. In
Figure 5, before the computers in WAN (PC-2, PC-3) can visit the IP Camera-1, must put