Vonnic C909IP H.264 Wireless 802.11b_g_n IP Network Camera - Manual (Page 20)

H Series IP Camera User Manual – with Pan/Tilt of CMOS
20
2） Manufacturer’s DDNS and Third Part Dynamic DNS: Please refer to the content of the
part 6.2.
3） UPNP: UPNP stands for universal plug and play, if you started UPNP, once the IP
camera was connected into the LAN, it will communicate with the router of the LAN. It will
request the router to open a port to forward its own port. User doesn’t need to log in the
router to set the port forwarding.
Before using UPNP function, please make s ure the router’s UPNP function has
been triggered. Because there are so many different routers, and not all of them
can support UPNP. Please test if the router work well with the equipment, if not, we
would suggest you don’t enable this function.
7.3 Alarm Setting Page
7.3.1 External Alarm Input
Figure 21 below has listed the external alarm input setting. If the alarm input pins have
connected with an alarm detector (Figure 4) , please tick the “External Alarm”, and then you
will have enabled external alarm function. If the external alarm detector is open mode, please
tick “Open”, vice versa.
Figure 21
7.3.2 Motion Detection Setting
Figure 22
If user wants to monitor a certain area’s movement, please select the motion detection to
trigger alarm. The motion detection setting page is showed in Figure 22. This equipment