Vonnic C909IP H.264 Wireless 802.11b_g_n IP Network Camera - Manual (Page 8)

H Series IP Camera User Manual – with Pan/Tilt of CMOS
8
4 Network Connecting
Figure 5
I P Camera can be connected with other PC through router, switch or hub to establish a
network. Figure 5 shown connections.
4.1 Connection Instruction
Before visit the IP Camera, you should firstly connect it to the Network, supply the power to it,
and check if the light of RJ45 Socket is normal to make sure all of the communication links
are fluency. The connection method likes as Figure 5.
1) IP Camera-1 and IP Camera-2 are connected separately to 2 different LANs.
2) And these 2 LANs are already connected to the Internet. In order to get the LANs to be
connected to the Internet, they are required to be equipped with router and to apply for
the communication link from the local Internet Service Provider (ISP) and connect to it by
ADSL or optical fiber, etc.
3) PC-3 is connected to the Internet.
4.2 Visit Instruction
To visit the IP Camera, you should do some settings of IP Camera and Internet besides
getting the communication link fluency.
1) The PC and IP Camera are in the same LAN. If you want to use this PC to visit the IP
Camera, you need to make sure their IP address is at the same segment. Otherwise you
need to do the reset of the IP Camera’s IP address. For example, the IP Camera-1’s IP
address in Figure 5 is 192.168.1.139 (at the segment of 192.168.1), while the PC- 1’s IP
address is 192.168.0.175 (at the segment of 192.168.0), then you will be not able to visit
the IP Camera through the PC-1. You need to change the IP Camera- 1’s IP address to
192.168.0.139 firstly.