Swanstone WB-2218 - Installation - Manual (Page 10)

D Du us stt H Ha az za arrd d
When sanding Swanstone product,
use a dust collection method which
prevents dust particles from going into the air. Always work
in a well-ventilated area. To keep the area well ventilated,
open windows and use exhaust fans. Always use an OSHA
approved dust mask when cutting, drilling, or sanding
Swanstone products.
2. Trial fit side splash to vanity top checking for proper fit.
Sand and trim, as needed.
3. Clean the surfaces to be bonded with denatured alcohol,
removing all dust and contaminants. Allow the surfaces to
dry completely.
S So ollv ve en ntts s H Ha az za arrd d
Follow all manufacturers’
safety instructions for silicone
sealants and denatured alcohol. Alcohol vapors are both
flammable and hazardous to breathe. Silicone vapors may
irritate eyes and nose. Personal injury can result from
improperly handling or use of products, such as denatured
alcohol. Always follow the manufacturer’s
recommendations for the safe use of these products.
Ventilate any work area before beginning to apply silicone
sealants, cleaning agents, or solvents.
4. Apply a thin bead of adhesive or silicone onto back of side
splash panel and attach it to the wall. Wipe off excess
adhesive with denatured alcohol and allow adhesive to set
for 24 hours for maximum adhesion.
5. Caulk all seams between wall and side/back splash to
create a moisture barrier. If desired, use a proper color-
matched silicone sealant (not included).
The installation is now complete. DO NOT discard these
installation instructions. PLEASE LEAVE THEM WITH THE
HOMEOWNER.
Vanity Bowl Installation
Note: If vanity bowl installation is required to be ADA
compliant, refer to the wall mount installation and ADA
sections.
1. Determine desired installation and select appropriate
template.
2. Cut out the vanity top inside of template.
3. Locate the template, making sure the bowl will not
interfere with cabinet, wall mount, or plumbing.
4. Attach template to counter with masking tape and trace
inside template with a pencil.
VI-029
Drop-In Mount
Raised
Mount
VI-014
VI-015
WARNING
WARNING
The Swan Corporation – Swanstone 10 800-325-7008
Installation Procedure